Call us to get tree assistance like tree cutting, tree cut, bush felling, shrub cutter, stump cutter and many others across USA:


Click to call

Call us now +1 (855) 280-15-30






Model: Mercury Years: center bracket, 2 required.

Replacing the axle sway bar bushings on a Ford van/truck E, E or E Thanks for stopping by the Ozzstar channel!

-GlenSway Bar Bushing Moog: htt. Since the bushings are made of rubber, and they incur constant abuse from the van and the environment, they normally wear out much faster than the sway bar itself. If you have entry-level automotive-repair skills, you can remove the sway bar bushings on your Ford van in. Had to replace these bushings. The drivers side fell out but the passenger side seemed to be fused to the inside of the axle. I had to use a die grinder to g.

Remove the bushing from the bracket by hand.

Dec 12, the sway bar is a bar that runs acrossed the front of the van from strut to strut. It is bolted to the cradel and then has links that run from the bar to the strut to increase stability. The sway bar bushings are rubber mounts that hold the bar down to the treeremove.buzz bar runs though the mounts one each side where the bar and the cradel meet. If they are wore out you will normally hear a. Apr 18, At this point you should have two bushings installed, one on each side of the sway bar end.

The thin metal spacers (procteting the bushings) should be on the very top, and very bottom. Now you want to slide the (approx.) 4in grade 8 spacer on the bolt. The spacer will push up against the bushing protector on bottom of the sway bar end. Jan 27, With the vehicle in NEUTRAL, position it on a hoist. Remove the 4 bolts and the 2 stabilizer bar brackets.

Discard the 4 bolts. To install, tighten to 25 Nm (18 lb-ft).

Model: Thunderbird Years: 2 required Model: Mercury Years: center bracket, 2 required Model: Passenger Years: 2 required.

Remove the stabilizer bar. To install, reverse the removal procedure. Stabilizer Bar Bushing Replacement Instructions Click Here. Thank you again for trusting us with your problem. SBR Rear Sway Bar for Ford. This rear sway bar fits Chassis Engineering rear end kits for the Fords.

This is an excellent way to improve the handling and overall driveability of your street rod. Sway bars work best when you have both the.